Removal Of Mobile Parts - Luvata KCE series Betriebsanleitung

Removal of mobile parts

1. Fan motors - Disconnect the main power supply, detach fan
motor cable/s and any signal cables so that they do not
obstruct the removal. Remove the fan motors. CAUTION!
Due to the weight of 800, 910 and 1000 fan motors you
may need to use a crane.
Models Ø 500 - 630 - 710 mm - H
Models Ø 500 - 630 - 710 mm - H
1. Fan motors
2. Fan duct (partially riveted)
3. Top panel connection side
4. Front panel connection side
2. Fan shroud - Disconnect the main power supply, detach fan
motor cable/s and any signal cables so that they do not
obstruct removal. Remove the fan motors. Remove plastic
caps. CAUTION! Due to the weight of multi hole fan
shrouds, you may need the use a crane.
3. Header and return bend side panels - Remove caps. Un-
fasten the screws and remove top panel.
CAUTION! Metal sheet parts with sharp edges
V
(horizontal flow) or (vertical flow)
V
(horizontal flow) or (vertical flow)
5. Front panel hairpin side
6. Fastening brackets "H"
7. Fastening brackets "V"
8. Lifting support brackets
- single row of fan motors
- two rows of fan motors
47