Installation - Luvata KCE series Betriebsanleitung

42
KCE Ø 500 mm fans
Installation of single row motor models
Configuration H
1
1. Hook model at lifting points.
3
Position unit in order to obtain the
desired configuration.
5
Immediately peel off the protecti-
ve plastic film from casing and
place the caps in the lifting slots.
Configuration V
1
Hook model at lifting points
3
Transfer model to installation site,
secure it in position with adequate
fastening screws.
IMPORTANT:
During relocation and handling operations always use all the lifting points indicated on model, if necessary use a beam
in order to evenly distribute the suspended load.
2
Lift and place model on two woo-
den beams then mount the sup-
port brackets supplied with model.
4
Transfer model to the installation
site, secure in position with ade-
quate fastening screws.
2
1 2
3
Lift model and mount the support
legs supplied loose with model
(1-2-3).
4
Immediately peel off the protecti-
ve plastic film from casing and
place the caps in the lifting slots.
KCE Ø 500 E - Ø 630 - Ø 710 mm fans
Installation of single row motor models
Configuration H
1
Remove the top, side, front and
back panels of package, hook model
to lifting points and lift it.
3
Transfer model to installation site,
secure it in position with adequate
fastening screws.
Configuration V
1
Remove the top, side, front and
back panels of package, hook
model to lifting brackets and lift it.
3
1 2
3
Hook model at lifting points, ele-
vate it and mount the support legs
supplied (1-2-3).
5
Immediately peel off the protecti-
ve plastic film from casing and
place the caps in the lifting slots.
2
Remove base of package and
mount base support brackets sup-
plied loose with model.
4
Immediately peel off the protecti-
ve plastic film from casing and
place the caps in the lifting slots.
2
Place the model on two wooden
beams then position it to the desi-
red configuration.
4
Transfer model to installation site,
secure it in position with adequa-
te fastening screws.