Temperature Sensor; Storage And Transport; General; Fork Lift (Or Lift Truck) Transport - Dimplex Dhw 300Vd+ Montage- Und Gebrauchsanweisung

DHW 300VD+

2.5 Temperature sensor

2.5.1 Temperature sensor installation
position
R1 Air inlet sensor
R3 Domestic hot water sensor
R5 Domestic hot water renewable sensor (optional)
R12 Defrost end sensor
R13 Renewable sensor (optional)
2.5.2 Measured values temperature
sensor
Measured values NTC 10 sensor (R1, R3, R5, R12)
-20 -15
Temperature in °C
NTC-10 in k 67.7 53.4
15 20 25 30
14.9 12.1 10.0 8.4
Measured values PT 1000 sensor (R13)
Temperature
-30 -20 -10
in °C
PT 1000 in k 0.882 0.022 0.961 1.00 1.039 1.078 1.117 1.155 1.194
60 70 80 90 100 110 120 130 140 150 160
1.232 1.271 1.309 1.347 1.385 1.423 1.461 1.498 1.536 1.573 1.611
www.gdts.one
-10 -5 0 5
42.3 33.9 27.3 22.1
35 40 45 50 55
7.0 5.9 5.0 4.2 3.6
0 10 20 30 40
451905.66.07 · FD 9908
3

Storage and transport

3.1 General

The domestic hot water heat pump should always be stored and
transported packaged in an upright position, without being filled
with water. Short distances and a maximum incline of 45° are
permitted during careful transportation without accessories.
Transportation along inclines of 45° is only permitted with acces-
sories (siehe Kap. 3.4 auf S. 6). Ambient temperatures between
-20 and +60 °C are permissible during transport and storage.

3.2 Fork lift (or lift truck) transport

The domestic hot water heat pump must remain mounted on the
pallet when being transported with a fork lift. The lifting speed
must be slow. Because of its high centre of mass, the domestic
hot water heat pump must be secured against toppling. To pre-
vent damage, the domestic hot water heat pump must be low-
ered onto a level surface.
3.3 Manual transport (factory
default)
The wooden pallet can be used underneath the device for the
purpose of manual transportation. A second or third carrying po-
sition can be created with the help of ropes or carrying slings
(these may be wrapped around the cylinder casing and attached
to the water pipe nipples). When transporting the heat pump in
this manner (or with a hand truck), do not, under any circum-
stances, exceed the max. tilt angle of 45° (see illustration).
ATTENTION!
10
The device cover cannot be used for carrying (the cover cannot withstand
significant forces)
18.0
60
NOTE
3.1
When tilting, edges and the display must be protected from possible
damage
50
English
45°
45°
EN-5