Technical Data; Before Use; Operation - Silvercrest SBLL 5 A1 Bedienungs- Und Sicherheitshinweise

˜ Technical data
Rechargeable battery type: Lithium Polymer
Battery capacity:
Output power:
Bluetooth version:
®
Bluetooth device name:
Operation distance:
Frequency response:
Impedance:
Degree of protection:
Charging time:
Operation time:
Frequency band:
Max . transmitted power:
The specification and design may be changed
without notification
˜ Before use
NOTES:
All parts have to be unpacked and the
packaging material has to be removed
completely .
Before use, verify the package contents are
complete and undamaged!
˜ Charging
This product is equipped with a built-in
rechargeable Lithium Polymer battery . Fully
charge the product before use .
Connect the micro-USB cable
charging jack and the USB port of a PC or
11
a suitable USB charging power source .
The operating time for the product is 5 hours –
medium volume level (70 % volume) .
16 GB/IE
3 .7 V, 1300 mAh
5 W (RMS)
2 .1
SBLL 5 A1
approx .10 m
100 Hz to 20 kHz
4 Ω
IPX7 (protection
against the effects of
temporary immersion
in water for up to
30 minutes)
3 hours
5 hours
(at 70 % volume)
2402 – 2480 MHz
10 dBm
with the USB
13
NOTES:
The red LED lights up when charging and
6
goes out once charging is completed . The
charging time takes approx . 3 hours .
When the battery is low the voice prompt
says "Battery low" every 5 minutes to prompt
charging . If the product does not get recharged
after 15 minutes, the product is switching off
and the voice prompt says "Power off" .
Once charging is complete, disconnect the
micro-USB cable
13
˜ Operation
˜ Bluetooth connection
Switching on: Press and hold
blue LED flashes . The voice prompt says
7
"Power on" . The blue LED
The voice prompt says "Pairing . . . " . The blue
LED flashes quickly . The product has
7
entered into pairing mode .
Activate Bluetooth
®
Search for the products' Bluetooth
SBLL 5 A1 to enable pairing . When a
connection is established, the voice prompt
says "Your device is connected" and the blue
LED lights continuously .
7
Playing music: Press
music .
Increasing/decreasing volume: Press or
press and hold +
4
NOTE:
A signal tone will sound when the maximum/
minimum vol ume level has been reached .
Switching off: Press and hold
voice prompt says " Power off " .
NOTES:
The product automatically connects with
devices it has already been paired with before .
Once paired, the product automatically
switches off after 15 minutes if the product is
not playing .
When disconnecting the product after
pairing, the voice prompt says "Your device
is disconnected" . The blue LED
quickly .
from the power source .
until the
1
flashes slowly .
7
on your Bluetooth device .
®
name
®
to play / pause
2
or –
.
3
. The
1
flashes
7