The Print Menu And Printing/Transferring Reports; Printing On Paper; Data Transfer To A Usb Stick; Data Transfer To A Pc With Hürner Datawork - Hürner Weldcontrol 160-R Bedienungsanleitung

To work properly, the used printer has to support PCL (Printer
Command Language). Please refer to the manual of your
printer for more information. A list of supported printer
Important
makes is also available from Hürner Schweisstechnik on-line at
www.huerner.de
5.1

The Print Menu and Printing/Transferring Reports

When a data communication cable is connected, the machine displays
the Print Menu. According to the selection made in this menu, data
will be sent to the connected device: to a printer for print-out, to
a stick for temporary storage, or to a PC for further processing and
archiving.
Using the ñ and ò cursor keys, select "Print All Reports," "Print Com-
mission Number" or "Print Date."
The option "All Reports" causes all the welding reports stored in system
memory to be printed. The options "Print Commission Number" and
"Print Date" take the operator to the next screen in which the first
available commission number or the first available date is displayed.
Use the ñ and ò cursor keys to browse through the reports in system
memory and select the desired commission or date from which reports
should be printed or transferred (see Display 30). When the desired
one is found, the selection has to be confirmed by pressing the START/
SET key to start the data transmission to printer, stick or PC.
5.2

Printing on Paper

Printing starts automatically after a selection was made in the print
menu. Wait for all the selected reports to print off and the "Printing
finished" message to appear on the screen.
If a problem occurs while printing is in progress (no paper in bin,
paper jam, ink or toner used up), a "Printer not ready" message is
displayed. After the problem condition is cleared, printing resumes
automatically.
If the product recognizes a problem that cannot be cleared
while printing or data transfer is in progress, it does not
resume printing or transfer and displays a "Printing inter-
rupted" error message.
Info
5.3

Data Transfer to a USB Stick

Transferring welding reports to a USB stick requires the same steps as
printing them off on paper with a USB printer. The only difference is
that Instead of the USB cable of a printer, you stick the USB stick into
the USB A interface port of the product. When using a USB stick, too,
wait for all the selected reports to be transferred and the "Printing
finished" message to appear on the screen.
5.4 Data Transfer to a PC with HÜRNER DataWork
HÜRNER's welding data management application DataWork allows
downloading welding reports from a welding system directly into
the database on a PC. To do so, connect a USB cable from the PC to
the USB B interface of the welding system. Then launch the database
application HÜRNER DataWork and, in the Transfer menu, select the
Welding Unit --> PC option and in its sub-menu, USB Port. See the
DataWork user's manual for further information on direct download
of welding data to the DataWork database.
22
EN
HÜRNER WeldControl 160-R User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
PRINT MENU
***
>Print All Protocols
Print Commission No
Print Date
Enter Commission No.
++++++++++++++++++++
++++++++++++++++
***
Display 29
Display 30
Version April 2011