Entering Traceability Data Relevant To The Welding In The Spg Mode; How Welding Is Performed In The Manual Mode Is Explained From; Entering The Welder Id Code; Entering Or Changing The Commission Number - Hürner Weldcontrol 160-R Bedienungsanleitung

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Menu Item Setting
Standard
4.2 Entering Traceability Data Relevant to the Welding
in the SPG Mode
The welding process can be performed fully manually (Manual Mode)
or with the support of the hydraulic, control, and data logging/report
generation unit (SPG Mode), which displays all steps needed during
welding on the screen to the welder's attention or has him confirm
them, and which makes a report of the welding operation. No welding
report is generated when the welding is fully manual.
Below, this manual first presents the welding process in the SPG Mode.

How welding is performed in the Manual Mode is explained from

Section 4.4.
When the welding process is performed in the SPG mode, before the
welding proper starts, the machine requests the input of all welding
parameters and component traceability data that were enabled in the
Configuration Menu.

4.2.1 Entering the Welder ID Code

When the welding is started by pressing the START/SET key while Dis-
play 2 is showing, first the input of the welder identification code is
requested, if it is enabled in the Configuration Menu (see Display 6).
The code has to be an ISO-compliant code. It can be entered either
using the ï, , ñ, ò cursor keys and confirming the input by press-
ing the START/SET key, or by scanning it from a bar code with the
scanning pen.
When the code was properly scanned or entered, this is confirmed by
an audible signal.

4.2.2 Entering or Changing the Commission Number

From Display 2 or after the welder identification code was entered, the
machine requests the input of the job number, or commission number,
if it is enabled in the Configuration Menu. If a commission number
exists already in memory, this one is proposed. You can either confirm
it by pressing START/SET or change it using the ï, , ñ, ò keys and
then confirm the new number by pressing the START/SET key.
It is possible to select a previously saved commission number instead
of the one shown on the screen by pressing the ï and  cursor keys
simultaneously. This causes the letter "S" to show in the lower right-
hand corner of the screen, and you can scroll through the commission
numbers in memory using the ñ and ò keys, to select a number and
then confirm it by the START/SET key. This number will be used for the
next welding. To quit the scroll mode without selecting a commission,
press ï and  simultaneously once again or the STOP/RESET key.

4.2.3 Entering or Changing the Welding Number

From Display 2 or after the commission number was entered, the
machine requests the input of the welding number, if it is enabled in
the Configuration Menu.
If both the commission number option and the welding number option
are enabled in the Configuration Menu, the machine checks whether
Version April 2011
— M — In a sub-menu, the welding standard to be applied to the
welding can be selected.
HÜRNER WeldControl 160-R User's Manual
Description / Possible Data
Enter Welder Code
++++++++++++++++++++
++++++++++
Display 6
Enter Commission No.
++++++++++++++++++++
++++++++++++
Display 7
EN
13