Klarstein Beerkules Bedienungsanleitung Seite 38

EN
When you take out the beer
connector and CO
please press the white button down.
38
Change a new beer keg (5 liter universal keg)
When the beer in the keg runs out, before changing a new beer keg.
1. Adjust the CO pressure regulation knob to "-" switch to shut off the CO
2
and save the CO
2. Open the lid of the beer cooler, pull down the tap handle to release the rest gas in
the keg (maybe with some beer bubble).
3. Then take out the beer device and the beer barrel from the beer machine.
4. Remove the keg from the keg lifter and pull the piercing pin out of the empty keg
(see figure 21).
5. Then put the piercing pin into the new keg and put it all into the beer cooler.
Connect the gas-tube and beer tube from the keg lifter, by pressing the white parts
of keg lifter.
6. It is recommended to clean the tap mechanism when changing the beer keg each
time. Please refer to the below contents about cleaning.
When you take out the fastener of beer dispensing unit,
you can move this unit towards arrow indication.
connector,
2
Figure 20
.
2
Figure 21
supplying
2
Remove the
holder (right)
and turn the
handle in the
direction of
the arrow.
The holder
can then be
removed from
the beer keg.