Saving, Retrieving And Deleting Results; Cleaning And Storing The Device And Cuff - Beurer medical BM 16 Gebrauchsanweisung

sure as well as the value above which your blood pressure is
classified as dangerous.
The classification in the display shows the range of the meas-
ured blood pressure.
If the values for systolic and diastolic pressure are in two differ-
ent ranges (e.g. systolic in the grade hypertension range and
diastolic pressure in the normal range), the classification on the
unit always indicates the higher range (grade hypertension in
the example described).
Table for classification of blood pressure values (unit of
measurement mmHg) for adults:
Range Systolic
Normal range 105 – 119 60 – 79
Pre-hypertensive 120 – 139 80 – 89
blood pressure
range*
High blood pres- 140 – 159 90 – 99
sure - degree
High blood pres- ≥ 160
sure - degree
(*) Blood pressure range that might transfer to high blood pressure
Diastolic Action
Self check
Check with doctor
Consult your
doctor
≥ 100 Consult your
doctor
Adapted from JNC 2003

6. Saving, retrieving and deleting results

The computer automatically saves the blood pressure readings
of the last 50 measurements. When the 50 memory locations
are exceeded, the current oldest value is deleted.
You can display the memory as follows:
• Press the user selection button
zone, and press the M key to switch from memory to mem-
ory with sequence numbers.
• The saved measured values are continuously stored.
• Press the On/Off switch
• If you forget to switch off the computer, it will switch off auto-
matically after 1 minute.
Press the user selection button
zone, then press and hold the M key for approximately 5-sec-
onds to clear the data in the pre-designated memory zone.
The data in both memory zones – zone 1 and zone 2 may be
erased if any of the batteries is removed.

7. Cleaning and storing the device and cuff

• Clean the device and cuff carefully using a slightly damp
cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff under
water, as this can cause liquid to enter and damage the
device and cuff.
• If you store the device and cuff, do not place heavy objects
on the device and cuff. Remove the batteries. The cuff line
should not be bent sharply.
20
to select a memory
to turn the unit off.
to select a memory