Sirona inLab MC XL Handbuch Seite 13

Sirona Dental Systems GmbH
Using the cleaning set CEREC MC XL, inLab MC XL
Installing the chuck
61 77 161 D 3439
D 3439.103.01.07.02 02.2010
3. Clean the inside of the blocking clamp nut with a cotton swab and undi -
luted ethanol (commercially available cleaning alcohol).
4. Grease the stop edge of the chuck and the block clamping nut lightly with
the supplied grease. Do this using the rounded-off cotton swabs supplied
for this purpose.
5. Grease the thread of the block clamping nut lightly.
1. Place the chuck on a rigid support as shown and push the block clamping
nut on top of it until it locks in place.
Using the cleaning set
Cleaning the automatic block clamp
3