Gears; Pedelec Tuning Is Prohibited; Inspection Plan - Stromer ST2 S Bedienungsanleitung

If the pressure point remains soft, please refrain
from riding. The Stromer dealer must bleed the
brake.
You can avoid this problem by applying the
brake lever before transport and then fixing it in
this position using a strap. This prevents any air
from entering the hydraulic system.
When you come to clean the braking system,
please first read the instructions provided by the
component manufacturer.
You can get more information about your
S-Pedelec's brakes as well as cleaning and main-
tenance in the operating manual provided by your
manufacturer or on the manufacturer's website:
www.stromerbike.com/support

Gears

Gears are vital to your safety on the bike!
Please read the operating instructions supplied to
you by your manufacturer and familiarize yourself
with how to operate the S-Pedelec and switch
gears before your first ride. Allow your Stromer
dealer to undertake any work on your bicycle's
gears! Work that is improperly carried out endan-
gers your safety on the S-Pedelec!
58 59
Information regarding the gears of your
S-Pedelec can be found in the manufacturer's in-
structions at www.stromerbike.com/support and
on their websites on the Internet
S-Pedelec tuning is prohibited
Do not modify the S-Pedelec's technology
in any way. Manipulating the bike in any way to
increase performance or speed can lead to legal
problems and/or make the bike less safe to ride.
Possible legal implications:
• The S-Pedelec is required by law to be regis-
tered for approval and insured. All legal re-
quirements regarding the bike's configuration
and as stated by the road traffic licensing au-
thority must be adhered to.
• The manufacturer does not offer any kind of
guarantee, warranty or liability.
• Criminal consequences cannot be ruled out. For
instance, a negligent bodily injury may result
in a legal offence.
• Termination of bicycle insurance.
Possible technological implications:
• Tampering with the bike's technology may
limit its capabilities, cause defects or break the
bike parts.
• The motor and battery may become overloaded
and overheat. Consequences: Irreparable dam-
ages and risk of fire.
The brakes and other parts may become over-
worked. Consequences: Malfunction, overheating,
increased wear and tear.

Inspection plan

Modern S-Pedelec technology provides high
performance, but must be regularly maintained
by qualified persons. This requires specialist
knowledge and specialist tools. Leave the work on
your S-Pedelec to your Stromer dealer!
Work that you can safely perform yourself is
highlighted in bold. To ensure that your bicycle
remains in a safe condition and fulfills the condi-
tions of the warranty, the following terms apply:
• Clean your S-Pedelec after every ride and check
it for possible damage.
• Have inspections carried out by the Stromer
dealer.
• Check your S-Pedelec every 300 – 500 km or
every three to six months.
• Check that all screws, nuts and quick release
axles are secure.
• Use a torque wrench to tighten screw joints!
• Clean and grease moving parts (excluding
brake surfaces) according to the manufacturer's
instructions.
• Have paintwork touched up.
• Ask a specialist retailer to replace any broken
and worn parts.
You can get more information about your bi-
cycle's parts as well as cleaning and maintenance
in the operating manual provided by your manu-
facturer or on the manufacturer's website:
www.stromerbike.com/support