hager RTD111X Anleitung Seite 9

RTD111X
Connection and status
Relay connections and status displays
+
Operating voltage from external
Power supply 9 - 30VDC
−
Ground for 9 - 30VDC input
OK
Not used / no function
LED status displays
Power
K1 K2 K3 K4
Status display in the Web interface
www.hager.com
K5 K6 K7 K8
ACT LNK
Subject to technical changes
+ − OK OK
NETWORK
NETWORK
INPUT
INPUT
C Relay (NO contact) potential-free,
max. 48V / 3A
K
K
Relay (changeover) potential-free,
max. 48V / 3A
C
NC
Power (green) Continuously on: The device is supplied with
power and is in operation.
K1-K8 (red) Off: Contact is not connected.
Flashing: Contact is connected within the
defined function sequence or time interval.
Continuously on: Contact is permanently con-
nected.
ACT (green) Short flash: signals data traffic
LNK (orange) Continuously on: The IP relay is connected to
the network.
The switching state of the contacts are also displayed in the
Web interface of the IP network relay.
This allows remote checking of whether the configured function
is being properly carried out.
9