System Settings; Administration Settings - Hager Rtd111X Anleitung

RTD111X

System settings

Administration settings

Network settings
Here is where you can configure the IP network relay to match
an existing network. "DHCP" retrieves an IP address from the
router. "DHCP with fallback" uses the manually configured
IP address if no IP address can be dynamically retrieved. The
"Manual" option uses the values entered.
Update section
For maintenance and service, this menu allows the settings to
be backed up, the device can be reset to factory settings or a
firmware update can be carried out.
Switching function by HTTP request
Relay functions can also be carried out by HTTP request (e.g.
with IP telephones or house automation controllers). Information
about the URL form can be found in the IP system manual.
The configuration of "relay masking functions" or "switching functions via HTTP request" can be combined with additional
devices (e.g. IP door speaker). You can find detailed information in the IP system manual.
www.hager.com
Access data
At the factory, the IP network relay is secured with a very simple
password (1234). After completing installation work, this should
be changed. Enter the new password and repeat it. Click "Save"
to confirm the input.
Special application cases
Relay masking function
A customisable relay mask can be used to implement complex
switching sequences of multiple relays. Each individual switch-
ing contact can also be defined with a separate switching time.
Application example: Door opening and release of the lift for a
particular floor.
Subject to technical changes 13