Safety Instructions; Functional Principle - Hager Rtd111X Anleitung

RTD111X
Introduction / Connection and power supply
Table of contents
Introduction

Functional principle

Network connection and power supply
Relay connections and status displays
Factory settings

Safety instructions

The installation and assembly of electrical equipment may only be carried out by an electrician in compliance with applicable in-
stallation standards, directives, regulations, safety and accident ordinances for the local country. When working on systems with a
230 V~ power connection, the safety requirements of DIN VDE 0100 must be met. Failure to comply with the instructions can cause
damage to the device, fire or other dangers. These instructions are a component of the product and must remain with the end cus-
tomer.
System information and intended use
This device is a product of the IP door intercom system and can only be used within the defined installation scenarios. Detailed
technical knowledge from IP training is assumed in order to understand them. The function of the device depends on its configura-
tion. You can find more information about the specific functional scope in the corresponding application descriptions in the product
database.
Functional principle
Sequence of switching functions
The IP network relays always responds to status mes-
sages of the IP door speaker module. This can be differ-
ent operating modes or switching commands that are
triggered from indoor client by DTMF code. See page
13 for other options for contact triggering.
8
8
8
9
9
10
Network connection and power supply
DTMF-CODE
STATUS
FUNCTION
IP network relay with 28VDC power supply
The IP network relay is connected to a power supply (9 - 30VDC) and an
Ethernet switch. We recommend the use of the RED013X power sup-
ply. The power supply can also operate additional system components,
such as the IP door speaker module, IP camera module and IP intercom
server.
Subject to technical changes
Reset to factory settings
Access through the IP intercom server
Basic relay settings
Administration settings
Special application cases
- +

L N
10
11
12
13
13
+ −
NETWORK
INPUT
www.hager.com