Husqvarna FS7000 D Bedienungsanweisung Seite 17

7. Remove the blade shaft bolt (A).
20–48"
D
C
B
A
60"
D
G
B
A
Note: The blade shaft bolt on the right side of the
product has a left thread. The blade shaft bolt on the
left side of the product has a right thread.
8. Remove the outer blade flange (C) and the flat
washer (B).
WARNING: Damaged or dirty parts can
prevent correct installation of the cutting
blade. Examine the blade shaft bolt, the
blade flanges, the flat washer and the
blade flange arbor for damages. Replace
worn or damaged parts. Clean the
contact surfaces of the cutting blade and
the blade flanges.
9. Put the cutting blade (D) on the outer flange arbor.
10. Install the cutting blade and the outer flange into the
inner flange (E). Make sure that the locking pins (F)
go through the blade and into the inner flange.
11. Install the flat washer and the blade shaft bolt.
1223 - 002 - 09.07.2019
E
F
E
F
C
12. To remove play, turn the outer flange and the cutting
blade in the opposite direction of which the cutting
blade rotates.
13. Hold the cutting blade tightly while you tighten blade
shaft bolt with the blade shaft wrench.
14. FS7000 DL: For a 1500 mm/60 in. cutting blade,
tighten the 6 bolts (G) that hold the outer blade
flange.
15. Push the switch for cutting depth adjustment down to
lower the cutting blade until it touches the surface.
CAUTION: Do not lower the cutting
blade too quickly. If the cutting blade hits
the surface with force, the cutting blade
can become damaged. Decrease the
speed with the knob for adjustment of
the blade lowering speed.
CAUTION: Do not let the front weight of
the product push down on the cutting
blade. This causes damage to the
cutting blade.
16. Tighten the blade shaft bolt fully with the blade shaft
wrench. The resistance between the cutting blade
and the ground keeps the cutting blade in position.
17. Lower the blade guard front and put the blade guard
latch on the front bolt of the blade guard. Tighten the
front bolt of the blade guard.
17