Diamond Blades - Husqvarna FS7000 D Bedienungsanweisung

maintenance of the cutting blade. Those warnings are
supplied with the cutting blade.

Diamond blades

WARNING: Make sure that the diamond
blade rotates in the direction of the arrows
shown on the diamond blade.
CAUTION: Always use a sharp diamond
blade.
There is a wide range of diamond blades that is used for
different operations. From new made concrete to
concrete and asphalt that has become hard and for
different hardness classes.
Diamond blades has a steel core with segments that are
made of industrial diamonds.
Water cooling system
Always use water during operation to keep the
temperature of the diamond blades down. The water
cooling system also increases the lifetime of the
diamond blades and prevents dust buildup.
Make sure that the water supply is not clogged.
To sharpen the diamond blades
Diamond blades can become blunt if you use an
incorrect feeding pressure or when you cut materials
such as hard reinforced concrete. If you use a blunt
diamond blade it becomes too hot, which can cause the
diamond segments to come loose.
• Decrease the cutting depth and the engine speed for
a short time to sharpen the diamonds on the
diamond blade.
Diamond blades for wet cutting
CAUTION: Always use a blade flange
dimension that is specified for the current
blade dimension. Do not use blade flanges
that are damaged.
During the operation, the friction causes the diamond
blade to become very hot. If the diamond blade
becomes too hot, it will decrease the blade tension or
make the core crack.
Let the diamond blade become cool before you touch it.
1223 - 002 - 09.07.2019
• Diamond blades for wet cutting must be used with
water to keep the diamond blade core and segments
cool during cutting. Diamond blades for wet cutting
can not be used dry.
• If you use diamond blades for wet cutting without
water, the diamond blade can become too hot. This
gives bad performance, blade damage and is a
safety risk.
To fill fuel
CAUTION: Always use correct fuel type.
Incorrect fuel type causes damage to the
product.
CAUTION: Do not use biodiesel. Biodiesel
causes damage to the fuel hoses.
• Use diesel fuel of the correct type. Refer to
Technical data on page 44 . For more information
about the fuel, refer to the engine manual supplied
by the engine manufacturer.
To adjust the position of the operation
handles
1. To adjust the length of the operation handles, loosen
the locking knob (A).
2. Adjust the operation handles to applicable operation
length.
3. Tighten the locking knob (A).
4. To adjust the height of the operation handles, turn
the locking knob (B) counterclockwise.
5. Adjust the operation handles to applicable operation
height.
6. Turn the locking knob (B) clockwise to lock the
operation handles in position.
B
A
15