To Replace The Oil In The Gearbox - Husqvarna FS7000 D Bedienungsanweisung

To replace the oil in the gearbox

There are 2 alternatives for how to drain the oil from the
gearbox.
1. To drain the oil with a manual oil pump, do this
procedure:
a) Remove the plug in the inspection window at the
front of the product (A).
C
b) Use an oil pump (B) to drain the oil through the
inspection window.
2. Remove the left screw (C).
3. To drain the oil through the hole below the engine,
do this procedure:
a) Put a container below the engine.
b) Loosen the screw and let the oil run out into the
container.
c) Tighten the screw.
36
B
A
4. Fill oil into the tube while you look through the
inspection window.
5. Fill until you see that the oil level is correct.
6. Tighten the left screw.
To replace the fuel filter
WARNING: Use protective gloves to prevent
skin irritation. Fuel can come from the fuel
filter and onto your skin.
1. Close the valve of the prefilter. For more information,
refer to the engine manual.
2. Turn the fuel filter counterclockwise to remove it.
3. Replace the fuel filter.
4. Fill the new fuel filter with diesel fuel.
5. Lubricate the seal with some drops of diesel fuel.
6. Install the fuel filter.
7. Open the valve of the prefilter before you start the
engine.
To replace the radiator coolant
WARNING: Risk of burn injuries. Let the
engine become cool before you open the
radiator coolant lid.
1223 - 002 - 09.07.2019