Diamond Blades - Husqvarna K1270 II Bedienungsanweisung

• Cutting blades applicable to this product are
available in two basic models; bonded abrasive
blades and diamond blades.
• Make sure that the cutting blade has the correct
center hole dimension for the installed arbor
bushing.
Cutting blade vibration
CAUTION: If you use the product with too
much force, the cutting blade can become
too hot, bend and cause vibrations. Use the
product with less force. If the vibrations
continue, replace the cutting blade.
Bonded abrasive cutting blades
WARNING: Do not use bonded abrasive
cutting blades together with water. Moisture
decreases the strength in the bonded
abrasive cutting blade and the cutting blade
can break and cause injury.
A bonded abrasive cutting blade is made of small
abrasive grains joined with an organic or vitrified bond,
molded with fabric reinforcements, which prevents the
cutting blade from breaking during high speed operation.
Bonded abrasive cutting blades for different
materials
Note: Make sure that you use the correct cutting blades
for rail cutting.
Blade type Material
Concrete Concrete, asphalt, stone masonry,
blade cast iron, aluminum, copper, brass,
cables, rubber and plastic.
Metal blade Steel, alloy steel and other hard met-
al.
Cutting blade Rail
for rail cutting
988 - 002 -
To examine a bonded abrasive cutting blade
• Make sure that there are no cracks or damages on
the cutting blade.
• Hang the cutting blade on your finger and hit the
cutting blade lightly with a screwdriver. If you do not
hear a clear sound, the cutting blade is damaged.

Diamond blades

WARNING: Diamond blades become very
hot when used. A diamond blade that is too
hot gives bad performance, blade damage
and is a safety risk.
WARNING: Do not use diamond blades to
cut plastic material. The hot diamond blade
can melt the plastic, which can cause a
kickback.
• Diamond blades have a steel core with segments
that are made of industrial diamonds.
• Diamond blades are used for masonry, reinforced
concrete and stone.
• Make sure that the diamond blade rotates in the
direction of the arrows shown on the diamond blade.
xxxx
11