switel E1502 Bedienungsanleitung Seite 23

Connect the base unit
1. Plug the connector on the cable end into the corresponding jack on the
rear side of the base and plug the power adaptor into the wall socket.
2. Plug the small connector on the end of the telephone line cord into the
corresponding jack on the base and plug the other end into the telephone
jack.
Note: Guide the power adapter cable through the strain-relief tab on the
base.
Important: Use only the power adaptors, telephone line cord and
batteries supplied with your phone, otherwise your phone may not
work. Do not block access to the wall power supply with furniture or
other items.
Connect the cordless handset
1. Open the battery compartment and insert
the rechargeable batteries. Observe the
correct polarity.
2. Slide the battery compartment cover
towards the centre of the handset until it
clicks into place.
For a full charge, the handset must be left in
the base unit for at least 16 hours (check the
base unit's power supply!).
Important: Use only the batteries
supplied with this product.
If the batteries need to be replaced later
on the same battery type must be used.
3
2
1
21