Reich 3545 Technische Daten, Ersatzteilliste Seite 5

3545
7 TRouBLES aND REMEDIES
Disconnect nailer from hose before servicing. When connecting the tool, it must contain no fasteners.
TRouBLE
air leaking from exhaust
port.
air leaking from release
valve (70 000) (light blowing
permissible)
Blow does not take place.
Idle impact or nails are not
fully driven in.
Nails head bend and
protrude from wood.
Nailer operates too slowly.
Set of wear-and-tear parts
During repair replacement of parts the special grease (code no. 68 3868) must be applied to the surface of
the cylinder and the counter surfaces of the O-rings.
Karl M. Reich Verbindungstechnik
PoSSIBLE CauSE
o-rings (e, f, g, h) damaged or dirty.
Release valve damaged.
Nailstrip jammed.
Safety trip (a) secured because no
nail is pressing on no-load-lock (i).
The magazine is empty or the nailstrip
jammed.
Tool is applied too weakly for too a
short time.
Tool exhausts considerably in the
lowest position of the piston, o-ring
(t), bumper (u, v) worn or damaged.
No backstroke.
Tool without sufficient lubrication.
air pressure too low.
Tool jumps.
Connection hose too long. Diameter
reduced in the air line or in the
maintenance unit (fall of pressure).
Piston completely (r) damaged.
Piston is not arrested in bumper (v);
bumper worn.
Tip of driver worn.
Bad nail strips.
Tool without sufficient lubrication.
Control parts frozen-up.
Code No. 73 3075
REMEDY
Clean or replace parts.
Have tool checked by service
workshop.
Remove the obstruction.
Pull back and release pusher or insert
nail strips.
Apply tool more firmly
Replace damaged parts.
Clean the interior pieces, grease the
counter surfaces of the o-rings and
the surface of the cylinder. Check the
lubricator.
adjust to correct air pressure (min. 6
bar / 0.6 MPa).
Press tool more firmly onto the
workpiece.
Investigate and correct trouble.
Replace piston. at the same time
check bumper (v) for wear.
Replace bumper .
Grind face of driver tip.
use proper REICH nail strips.
Clean the interior pieces, grease the
counter surfaces of the o-rings and
the surface of the cylinder. Check the
lubricator.
Check operation of water separator.
English I 5
REICH ®