Operation - HANSGROHE AXOR Steel series Montageanleitung

Assembly
The fitting must be installed, flushed and
tested after the valid norms!
1. Flush through the supply pipes.
2. Mount the ball S - unions.
3. Fasten the mixer using ball union nuts, align
and tighten it.
The ball - S - unions enable inaccuracies in
the wall installation to be compensated for,
whether in the horizontal direction, in the vertical
direction or in the parallel orientation.
4. Fit on the spout body / shower hose connection
and tighten the allen screw.
5. Push the moulding strip onto the rim of the
escutcheon.
6. Add the escutcheon and tighten the nut.
7. Fit on flange.
8. Mount the lever head, tighten the allen screw
and fit on stopper.
Large differences in pressure between the hot and
cold water supply should be balanced.

Operation

The mixer is actuated by pulling the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
35402800: The flow is changed from bath to shower
function by pulling the knop at the upper side of the
spout. After shutting off the water flow, the mixer
returns automatically to the bath function.
Fault
Insufficient water
Mixer stiff
Mixer dripping
Hot water temperature too low
Instantaneous heater didn't work - Flow limiter in handshower isn't
English
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
Technical Data
Operating pressure:
Recommended operating
pressure:
Test pressure:
Hot water temperature:
Recommended hot water temp.: 65° C
Centre distance:
Connections G 1⁄2":
Rate of flow by 3 bars:
anti-pollution function
Spare parts (see page 3)
1
1.1 screw cover
2
3
4
5
6
7
8
9
10 selector cpl.
11 diverter knob
12 non return valve
13 aerator cpl.
14 spout cpl.
Cause
- Shower filter seal dirty
- Non return valve hasn't moved
back
- Cartridge defective, calcified
- Cartridge defective
- Hot water limiter incorrectly set
removed
- Filter are dirty
- Non return valve didn't move
back
handle
flange
escutcheon
nut
cartridge cpl.
locking screw
seal
noise reduction
ball S - unions
ball S - unions 120 - 180 mm
Remedy
- Clean filter seal between shower
and hose
- Exchange non return valves
- Exchange cartridge
- Exchange cartridge
- Set hot water limiter
- Remove flow limiter
- Clean the filter / exchange filter
- Exchange non return valves
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
150 ± 16 mm
cold right - hot left
approx.22 l/min
35492800
96681000
96691800
13983800
96692000
92730000
96059000
95008000
94073000
13989000
13988000
94077000
96693800
94074000
13485800
96694800
7