Storch Spider Handbuch Seite 64

Commissioning/Decommissioning
Make sure that the mains voltage is the same as that
shown on the type plate of the device and that the
switch is set to "OFF" before the device is connected
to the mains.
Switching the Device On and Off
To switch on:
While holding the column with the left hand and the
main handle with the right hand, use the thumb of
your right hand to set the rocker switch to "ON". Be
prepared for the start-up torque when you switch the
device on.
To switch off:
Set the rocker switch to "Off". After switching the
device off, the sanding disc will continue to rotate for
a short while. Take care that no parts of your body
touch the disc, and do not put the tool down as long
as the disc is still rotating!
On/Off switch
Adjusting the rotation speed:
The device speed can be adjusted to suit different
requirements/surfaces. With the help of the speed
control, it can be adjusted from 650 to 1600 rpm.
Using the right thumb, turn the control downwards
(counterclockwise) to increase the speed or upwards
(clockwise) to decrease the speed. Generally, you should
use the higher speed for fast stock removal and the
lower speed for fine processing.
Speed control
POSITIONING THE SANDING HEAD:
There are 2 positions for the sanding head: one for
walls and one for ceilings.
These adjustments allow a more ideal range of motion
for the different angles involved.
For the position for ceilings (position A in the figure),
the pivot is attached to the very end of the fork.
For the position for walls and other surfaces (position
B in the figure), the pivot is attached to the centre
position of the fork.
To adjust the device, pull the 2 spring-loaded catches
outwards, slide the pivot to the new position, and allow
the catches to snap into place.
Spring-loaded catches
64