Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5
Maintenance
5.1
Safety notes for maintenance
5.2
Maintenance plan
In normal use, it is recommended that an inspection is performed every six months to
check for external damage, correct functioning and leak tightness.
In addition, the appliance must undergo a general overhaul every six years, to be
performed by TESCOM EUROPE, including a replacement of all wearing parts.
6
Faults
The following section describes possible causes of malfunctions and how to eliminate
them. If malfunctions occur with increasing regularity, shorten the maintenance intervals
to reflect the actual load. If malfunctions occur that cannot be eliminated with the
following help, please contact the manufacturer (see Section 1.7 customer service).
6.1
Troubleshooting
NOTE!
Maintenance may only be performed by
sufficiently qualified, trained and authorised
individuals (see section 2.4), only using original
spare parts.
DANGER!
Damaged equipment or equipment that is not
working properly must not be used.
NOTE!
If the appliance is used to an unusually high
degree, the intervals between maintenance might
be shorter.
WARNING!
Use only original parts.
The repair and maintenance of the equipment
is only permitted using genuine parts from
TESCOM. The use of incorrect or defective spare
parts can result in risks for the operating staff and
in damages, malfunctions or total failure of the
system. The safety instructions for removal and
disposal, see Section 7.1, must be observed
39
GB
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
