Operator's Responsibility - Tescom SG 1-Serie Gebrauchsanweisung

NOTES ON
CYLINDER PRESSURE
REGULATORS
DEVICE MARKING
AND SIGNING
2.3

Operator's responsibility

OPERATOR
OPERATOR'S DUTIES
WARNING!
Connecting cylinder pressure regulators!
With cylinder pressure regulators, the inlet con-
nector must directly fit the cylinder valve con-
nection. The use of adapters is not permitted.
The way the inlet connector is fitted may result
in a maximum permissible inlet pressure, which
is less than the specified maximum inlet pres-
sure on the regulator. The system components
have to be checked with regard to operating
pressures and materials. When changing the
type of gas, the pressure regulator should be
sufficiently purged with an inert gas.
WARNING!
Danger from illegible signs!
Labels and signs can gather dirt or become
otherwise illegible over time, thus preventing
the recognition of risks and compliance with
the requisite operating information. This could
result in injury.
Make sure all safety, warning and operation
information is legible at all times. Immediately
replace any damaged signs or labels.
The operator is the person who operates the
system for commercial or business purposes or
who provides the system for use/application
by a third party, and who bears legal product
responsibility for protecting the user, staff or
third parties during operation.
The system is used for commercial purposes.
The operator of the system is therefore subject
to health and safety obligations. Compliance
with the safety, accident prevention and
environmental protection regulations that apply
for the use of the system is mandatory, in
addition to the safety information in these
instructions.
THE FOLLOWING APPLIES IN PARTICULAR:
• The operator must be aware of the
applicable health and safety regulations and
must perform a risk assessment to identify
risks that may occur as a result of the
specific working conditions at the site where
the system is operated.
31
GB