Technical Data - EINHELL ELE 2000 Bedienungsanleitung

GB
cord must have a cross-section width of 3 x 1.5
mm 2 and be designed for outdoor use.
Avoid pinching the power cord at all costs when
b
dragging under doors and guiding through
windows. Avoid kinking the power cord, which
can occur through improper placement or
guidance. Replace all power cords at the first
sign of splitting (which normally results from
age).
Safety pictograms on the tool (Fig. 10)
1. Read the directions for use before operating the
tool.
2. Wear ear plugs, a visor and safety goggles.
3. Do not use the tool in rain or snow. Do not
expose the tool to wet conditions.
4. Unplug the power cord if it starts to coil.
5. Maintain a safe distance from other persons.

4.0 Technical data

AC motor
Output
Air velocity
Suction rate
Volume of debris bag
Sound volume level LWA
Sound pressure level LPA
Vibration ah
5.0 Assembly
5.1 Mounting the additional handle (Fig. 2)
Push the additional handle (2) onto the housing
b
and tighten it with a fastening screw (7). We
advise that you mount the additional handle at a
right angle to the blower/vacuum tube.
5.2 Installing the pre-screen (Fig. 3)
Install the pre-screen (8) by placing it inside the
b
debris bag frame (5).
5.3 Mounting the debris bag frame (Figs. 4, 5)
Hang the inserted pre-screen (8) on the nose
b
(9) of the vacuum tube (1), then slowly pull the
debris bag (5) upward.
10
b
The garden blower vac is equipped with a safety
lock-off switch which only works when the debris bag
(5) has been properly mounted to the garden blower
vac.
6.0 Prior to starting up
b
7.0 Starting up
7.1 Sizing the strap (Fig. 1)
b
7.2 Connecting the tool to the power supply and
230V ~ / 50 Hz
switching on (Figs. 6, 7)
1800 watts
28.9 m/s
b
680 m3/h
b
approx. 50 l
108,8 dB (A)
b
95,8 dB (A)
< 1 m/s
2
7.3 Selecting the mode of operation
7.3.1 Vacuum (Fig. 8)
b
b
7.3.2 Blowing (Fig. 9)
b
b
Clip the debris bag frame (5) onto the housing
hook (10).
Start up the tool only after it is fully assembled.
Always inspect the tool power cord for damage
before starting up. The tool may only be used if
the cord is in flawless condition.
Size the length of the carrying strap (3) so that
the vacuum tube just clears the ground.
Plug the tool plug into the power cord coupling
(extension).
Secure the power cord (11) with the sleeve
found on the tool as shown.
To switch on, hold down the On/Off switch (4).
Release to switch off.
Turn the switch (12) all the way left to
„Vacuum". You can do this regardless of
whether the tool is running or not.
Swing the vacuum tube in a steady movement
above the debris you want to pick up, keeping
the tube approximately 3 cm above the material.
Turn the switch (12) all the way right to
„Blower". You can do this regardless of whether
the tool is running or not.
Channel the air stream forward and walk slowly
to blow foliage or garden refuse into a pile or
clear out hard-to-reach places.