Storage; Assembly - SystemAir Aj8 Montage- Und Betriebsanleitung

10.2 Storage

Provided the original packaging is intact and there is no build-up of condensation, the jet fan can be stored in the
original packaging (polythene sheet with ground clearance) out of doors for up to one month. The unpacked fan must
not be stored out of doors. In a dry, well ventilated room without risk of condensation build-up, the jet fan can be stored
indoors for up to 6 months.
Storage temperatures: –20 °C (–4 °F) to 60 °C (+140 °F).

10.3 Assembly

All fans are tested at the factory before shipping.
Proceed as follows after removing the packaging:
•
Check for damage sustained during transport,
•
Manually check whether the impeller turns without obstruction, and
•
Make sure no condensation has formed.
GER!
R!
Status: 14.10.2008
Attention!
Risk of damage to the fan.
If the fan is stored longer than three months, turn the impeller by hand regularly.
Danger!
Danger of personal injury if safety instructions are not observed.
Make sure general rules and regulations for occupational safety are observed when
installing the fan.
Danger!
Danger of personal injury if the fan falls.
Make sure all parts and any areas required for preparation are inaccessible to unauthorized
persons during installation.
Danger!
Danger of personal injury from electrical current.
Make sure the fan is disconnected from the power supply before making any electrical
connections in the fan. Make sure the electrical power supply cannot be inadvertently
switched on while working on the fan.
All electrical connections in the fan must be made by a qualified electrician.
Danger!
Danger of personal injury from rotating parts.
Make sure the fan cannot be inadvertently switched on and the impeller cannot be
inadvertently accessed while installation work is being performed on the fan.
Attention!
Risk of damage to the fan.
The housing of the fan must not be deformed during installation.
Exercise caution when installing the fan.
Attention!
Risk of damage to the fan.
Turn the impeller manually to make sure it is unobstructed.
Do not install the fan if the impeller does not turn easily and without obstruction. Notify the
manufacturer.
Attention!
Risk of damage to the fan.
Make sure the fan cannot take in foreign bodies.
Systemair GmbH, Seehöfer Str. 45, 97944 Windischbuch
Phone: +49 (0) 7930/ 92 72 0, Fax: +49 (0) 7930/ 92 72 92
E-mail: info@systemair.de, Internet: www.systemair.com
Jet Fans (e)
Page 9 of 19