Listening To The Radio - auna Oakland DAB Bedienungsanleitung

LISTENING TO THE RADIO

FM radio
1. Turn the volume knob in a clockwise direction to turn the equipment on.
2. Use the function selector to select TUNER mode.
3. Use the radio band selector to select the desired band (AM, FM or FM-
Stereo).
4. Turn and hold the tuning knob for a few seconds to tune into a radio
station. The unit will start searching automatically and stop when a radio
station is found. Release the knob once a station has been found.
5. Repeat the above step until your desired radio station is found.
6. Adjust the volume knob to your desired volume level.
7. AM reception: the receiver has a built-in AM bar antenna. If reception is
weak, slightly rotate or reposition thet unit to improve AM reception.
8. FM reception: the receiver has a built-in FM wire antenna hanging at
the rear cabinet. For best reception, completely unravel and extend this
wire.
FM and FM-stereo mode
• FM mode: use the radio band selector to select the FM band. Programs
are received in mono mode. Use this mode when stereo reception is
weak.
• FM-Stereo mode: use the radio band selector to select FM-ST for
receiving stereo programs. Once a stereo signal is received, the ST icon
will light up on the display.
AM/FM Radio memorization for preselected channel
1. Turn the volume knob clockwise to turn the equipment on.
2. Use the function selector to select TUNER mode.
3. Use the radio band selector to select the desired band (AM, FM or FM-
Stereo)
4. Turn and hold the tuning knob for a few seconds to choose a desired
radio station need to save. Then press PROG button Press  or  to
set the Saved Number (such as P01,P02)
5. Repeat the 4th operation to save other preselect radio stations.
EN
37