Keypad - Starcom Systems Helios Installationsanleitung

Keypad

The keypad is used to arm and disarm the Helios and for driver identification. You can
program up to 50 keypads into the Helios memory.
To arm the system:

Enter (*) and press four times on the 4 button.
To disarm the system:

Press (*) and enter your PIN code. The key pad buzzer sounds to confirm the
operation.
To garage mode:

In Helios IDLE state, press (*) and four times on the 5 button.
To change/add the keypad PIN code:
In this procedure, you are editing the default codes.
Note:
1. In the Installer application, click Technical > Helios parameters > Driver IDs.
2. Click new and insert driver personal code (four digits).
5. Click Send Changes to complete programming.
Remote Devices
Figure 13 Keypad
25 Simulation Kit Manual