Inhaltsverzeichnis
Werbung
7.
Send a command and attach the Dallas to its socket.
8.
A green light acknowledges the Dallas has been programmed.
To program a new Dallas key using Starcom Simulator:
1.
Select a memory location for the Dallas iButton.
2.
Click Send. The simulator LED lights up.
3.
Insert the Dallas iButton in its socket for the duration of the programming (until
the LED turns off).
4.
Remove the Dallas iButton.
Important Note:
Pay attention to place the switch to DALLAS (DLS) position.
Remote Devices
DALLAS
Figure 11 Dallas iButton Switch
22
Simulation Kit Manual
Werbung
Inhaltsverzeichnis
