Inhaltsverzeichnis
Werbung
Serial Locking
This method requires the addition of two external relays. Wire them as follows:
Figure 9 Wiring External Relays for Serial Locking
Arm/Disarm
You can connect the Helios Arm/Disarm function either as a standalone system or in
conjunction with the existing system.
Standalone Arming
Arming is performed by passive arming, remote control, or transponder.
Disarming is performed by unlock, key pad, remote control, or transponder.
Connecting to the Existing Arm/Disarm System
Locate the existing alarm system brain and connect the Helios Arm pin (#14) to the
alarm system brain Arm pin with a diode. Also, connect the Helios Disarm pin (#17) to
the alarm system brain Disarm pin with a diode.
If the vehicle's existing alarm system uses (+) (+) commands,
Note:
insert external relays to swap the logic to (–) (–).
Installing the Helios
19
Simulation Kit Manual
Werbung
Inhaltsverzeichnis
