Tools Required For Installing The Helios; Before Installing; Installing The Helios - Starcom Systems Helios Installationsanleitung

Tools Required for Installing the Helios

The following tools are required for installing the Helios:

Electric drill and/or screwdriver

Cone drill

Adapter for Phillips (cross-head) screws

Phillips, flat-tip, and star screwdrivers – various sizes

Wire cutter

Test-lamp and/or voltmeter (use of voltmeter is preferred and recommended)

Electrical insulation tape

Regular and drilling head screws

Insulation sleeve or soldering iron and solder

Before Installing


Run the Installer application and click Technical > Unit Status to verify if the
type and model of vehicle-under-installation appears in the Wiring by Models table.
Study the available information before proceeding.

If the vehicle type is not listed in the table and you are in possession of the data
required for installation, add all the pertinent information.

For improved system security, it is recommended to vary the installation location
randomly for each successive installation.

Confer with the client as to the location of the keypad, Dallas button, emergency
button, and other service buttons.

Installing the Helios

It is very important before installing the Helios unit in vehicle to run
the Helios Wizard for latest Firmware version update and connectivity
test (TCP Test).

Use alcohol to clean the surface to which you have decided to attach the Helios.

Connect all the required wires in the cable to the Helios connector before
connecting the connector to the Helios.

Secure the Helios in its chosen location using cable ties and ensure proper
concealment of all wires.
Tools Required for Installing the Helios 15 Simulation Kit Manual