General Power Tool Safety Warnings; Work Area Safety - Parkside PSBSA 20-Li A1 Originalbetriebsanleitung

Noise emission value:
Noise measurement value determined in accordance
with EN 60745. The A-rated noise level of the
power tool is typically as follows:
Sound pressure level:
Uncertainty K:
Sound power level:
Uncertainty K:
Vibration emission value:
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 60745:
Hammer drilling in concrete:
a = 9.875 m/s 2
,ID
H
Drilling in metal:
2
a = 3.475 m/s
h,D
Uncertainty K = 1.5 m/s
Screws:
<2.5 m/s 2
Uncertainty K = 1.5 m/s
Wear hearing protection!
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for equipment comparisons. The
specified vibration emission value can also
be used to make an initial exposure estimate.
PSBSA 20-Li A1
L = 86.7 dB (A)
PA
K = 3 dB
PA
L = 97.7 dB (A)
WA
K = 3 dB
WA
2
2
WARNING!
► The vibration level will vary according to the
use of the power tool and may sometimes
be higher than the value specified in these
instructions. Regular use of the power tool in
this way may cause the user to underestimate
the vibration. Try to keep the vibration loads
as low as possible. Measures to reduce the
vibration load are, e.g. wearing gloves and
limiting the working time. Wherein all states
of operation must be included (e.g. times
when the power tool is switched off and times
where the power tool is switched on but
running without load).
General Power Tool
Safety Warnings
WARNING!
► Read all safety warnings and all instructions.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious
injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive atmos-
pheres, such as in the presence of flammable
liquids, gases or dust. Power tools create sparks
which may ignite the dust or fumes.
c) Keep children and bystanders away while
operating a power tool. Distractions can cause
you to lose control.
GB │
IE│ 15■