Maintenance And Repairs - Rosenbauer NAUTILUS 4/1 Verwenderinformation

CAUTION: Never place the pump on muddy ground! If necessary,
create a firm base (using e.g. stones); the base should be flat (< 10°).
You can also operate the pump in a hanging position on a working
rope.
CAUTION: Never use the cable for transporting, pulling out or
anchoring the submersible pump! When transporting the pump clip the
karabiner on the working rope into the eyes provided!
CAUTION: When routing hoses and cables, make sure that there are
no kinks and do not route over sharp edges.
3. Connect the plug: the NAUTILUS switches on automatically.
4. Do not allow the pump to run dry for extended periods of time; this can
cause unnecessary wear on the seals or overheating of the motor.
CAUTION: Position the plug in an area that is safe from flooding, and
protect it against moisture.
CAUTION: Whenever you work on the pump, pull the plug out of the
socket for safety reasons.
CAUTION: You must not use this pump in
explosion hazard areas.
CAUTION: You must not use this pump for pumping
flammable liquids.
5.3. Checking the direction of rotation
Due to the motor design, there is no need to check the rotational direction with
the NAUTILUS.

6. MAINTENANCE AND REPAIRS

CAUTION: Before starting maintenance or repair work, always discon-
nect the electric cable from the power supply to avoid inadvertent
enabling of the pump. Before starting work, make sure that all rotating
parts are stationary.
NAUTILUS 4/1 & NAUTILUS 4/1 ECO – Rosenbauer
EN
19