Technical Instruction - AsViva T16 Benutzerhandbuch

TECHNICAL INSTRUCTION

Belt adjustment
Factorywise the belt is correctly set up during manufacturing. Sometimes it is neccessary after few
weeks to adjust the belt after using the treadmill for several weeks.
Adjustment of the belt tension:
If you feel that the belt is sliding while running on it, you have to adjust the belt tension.
A. Turn clockwise in 1/4 steps on both sides as shown in the picture below.
B. Repeat this process until the sliding stops.
C. Please do not tighten the screws to hard, to avoid bearing defects.
Centering the belt:
Whilte running, you can step harder with one foot than with the other.
This can cause a missalignemtn of the belt.
A. Let the treadmill run with 6km/h without standing on it.
B. Look if the belt is running in the center..
a. If it's sliding to the left, please turn the left screw clockwise in 1/4 steps, if it slides to the right,
than screw the right screw anticlockwise.
b. If the belt is still not running in the middle, repeat step a until it runs in the middle.
C. Increase the speed to 16km/h and check if the belt is still running in the middle, otherwise repeat
step A and B.
D. If this process is unsuccessful, increase the belt-tension.
64
.