Replacing Complete Electronics Module - Endress+Hauser Promag 400 Index C Einbauanleitung

7

Replacing complete electronics module

7.1 Replacing electronics module without connection board
Remove the existing T-Dat (Fig. 4 below) from the existing electronics module, and
insert the T-Dat into the new electronics module. Check if the S-DAT is in the sensor
interface (Fig. 9).
1 →
T20
3 →
1.
4 →
Endress+Hauser
2 →
2.
2.
1.
3.
5 →
EA01099D
3 mm
9