Endress+Hauser Promag 400 Index C Einbauanleitung Seite 12

EA01099D
7.6 Note on assembling electronics module with connection board
The jumper (Fig. 1 below) must be removed prior to installing the amplifier. Ensure that
the S-DAT is inserted in the connection board (Fig. 2 below).
1 →
7.7 Note on assembling electronics module with connection board
and electronics module without connection board:
Otherwise, remove the S-DAT from the defective amplifier (Fig. 1 below) and install it in
the new amplifier (Fig. 2 below).
1 →
12
2
S-DAT
2
Endress+Hauser