Note On Assembling Electronics Module Without Connection Board; Note On Assembling Electronics Module With Connection Board And Electronics - Endress+Hauser Promag 400 Index C Einbauanleitung

EA01099D
12 Note on assembling electronics module without
connection board
Check if the S-DAT is inserted in the amplifier (Fig. 1 below). Otherwise, check if the S-
DAT is inserted in the sensor interface (Fig. 2 below).
1 →
S-DAT
13 Note on assembling electronics module with
connection board and electronics module without
connection board:
Otherwise, remove the S-DAT from the defective amplifier (Fig. 1 below) and install it in
the new amplifier (Fig. 2 below).
1 →
16
2
S-DAT
2
Endress+Hauser