Setting Up And Connecting The Refrigerator; Removing The Transport Protection - Waeco COOLMATIC R Serie Bedienungsanleitung

_r-kuehlschraenke.book Seite 30 Donnerstag, 14. Oktober 2010 4:34 16

Setting up and connecting the refrigerator

5.2 COOLMATIC RPD/RPF, RSD/RSF and RPA-40
control elements
No. in 3,
Explanation
page 3
A Temperature controller
B only RPA-40:
Accumulator button: interrupts compressor operation until
the stored cooling power is used up
6 Setting up and connecting the
refrigerator
6.1 Setting up the refrigerator
In continuous operation, the air humidity may not exceed 90 %.
Set up the refrigerator in a dry, sheltered place. Avoid placing it near heat
sources such as radiators, gas ovens or hot water pipes. Do not let it stand
in the full sun.
The refrigerator must be positioned so that heated air can dissipate easily.
Therefore make sure there is adequate ventilation (4, page 4).
No. in 4,
Explanation
page 4
1 Hot waste air
2 Cold intake air
3 Condenser
4 With cover panel 50 mm above
6.2

Removing the transport protection

The refrigerator has a locking mechanism to protect it during transport. The
following settings are possible:
– Position 1 (transport lock): (5 1, Page 4) The door is locked and se-
cured. To open the door, turn the bolt to position 2.
– Position 2: (5 2, Page 4) The door can be opened.
– Position 3 (VENT position): (5 3, Page 4) The door is slightly open,
but fixed. Use this position, for example, if you are not going to use the
device for a long time.
30
COOLMATIC R series