Waeco PerfectView CAM26W Montage- Und Bedienungsanleitung Seite 54

_RV-HD-STANDARD.book Seite 54 Montag, 28. November 2005 3:46 15
Installing the rear view system
➤ Drill Ø 6.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw the camera bracket on with the M6 x 20 mm threaded screws.
Creating a through-hole for the camera connection cable
(t, page 11)
If possible, use available openings – such as ventilation grilles –
to feed the connection cables through. If there are no existing
openings, you must drill a hole with a 30 mm diameter.
Check beforehand that there is sufficient room for the drill
head to come out on the other side.
➤ Drill a hole of Ø 30 mm near the camera.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤ Place cable sleeves in all sharp edged ducts.
Attaching the camera to the camera bracket
➤ Push the camera into the camera bracket (8 7, page 5).
➤ Push the camera guard over the camera bracket.
➤ Align the camera so that the lens points downwards on the road.
Use only the screws supplied to mount the camera in the camera
bracket. Longer screws will damage the camera.
➤ Secure the camera loosely with the two screws M4 x 10 mm
(u, page 11).
Do not tighten the screws until you have aligned the camera
(see "Aligning the camera" chapter on page 56).
But you first need to install and establish the electrical
connection for the entire rear view system.
54
PerfectView