Toshiba RAV-SM402MUT-E Installations-Handbuch Seite 26

8
APPLICABLE CONTROLS
Procedure example
Manual address setup procedure
While the operation stops, change the setup.
(Be sure to stop the operation of the unit.)
Procedure
Push simultaneously
shown below. Check the displayed CODE No. is [10].
• When the CODE No. is other than [10], push
1
erase the display and repeat procedure from the first step.
(After pushing
is not accepted for approx. 1 minute.)
(For a group control, No. of the firstly displayed indoor unit
becomes the header unit.)
Every pushing
Select the indoor unit of which setup is changed.
2
In this time, the position of the indoor unit of which setup is changed can be confirmed because fan and
louver of the selected indoor unit operate.
Using temp. setup
3
CODE No. [12]. (CODE No. [12]: Line address)
- 1
Using timer time
3
from [3] to [2].
- 2
SET
Push button.
3
In this time, the setup finishes when the display changes from
- 3
flashing to lighting.
Using temp. setup
4
CODE No. [13]. (CODE No. [13]: Indoor address)
- 1
Using timer time
4
from [3] to [2].
- 2
SET
Push button.
4
In this time, the setup finishes when the display changes from
- 3
flashing to lighting.
Using temp. setup
5
CODE No. [14]. (CODE No. [14]: Group address)
- 1
Using timer time
5
[0001] to [0002].
- 2
(Setup data [Header unit: 0001] [Follower unit: 0002])
SET
Push button.
5
In this time, the setup finishes when the display changes from
- 3
flashing to lighting.
English-25

3 4
-2, -2,
SET
CL TEST
+ + buttons for 4 seconds or more. After a while, the display part flashes as
TEST
button, operation of the remote controller
UNIT LOUVER
button, the indoor unit No. in the group control is displayed in order.
/ buttons, specify
/ buttons, change the line address
/ buttons, specify
/ buttons, change the indoor address
/ buttons, specify
/ buttons, change the setup data from
T
5
-2
TIMER SET M E FAN
7
SAVE A AVE
FILTER L LTER
RESET T CL CL SWING/FIX
1
Description
TEST
button to
Indoor unit No. before setup change is displayed.
Indoor unit No. before setup change is displayed.
Indoor unit No. before setup change is displayed.
25
ON / OFF
3 4
-1, -1,
MODE
2 6
VENT
,
UNIT LOUVER T
3 4
-3, -3,
(∗ Display changes according
to the model No. of indoor unit.)
5 6
-1,
5
-3