In Case Of Wireless Remote Controller - Toshiba RAV-SM402MUT-E Installations-Handbuch

7
TEST RUN

In case of wireless remote controller

Procedure
Turn on the power of the air conditioner.
1 When power is turned on for the first time after installation, it takes approx. 5 minutes until the remote controller
becomes available. In the case of subsequent power-on, it takes approx. 1 minute until the remote controller
becomes available. Execute a test run after the predetermined time has passed.
Push "ON/OFF" button on the remote controller, select [COOL] or [HEAT] with "MODE" button, and then select
2
[HIGH] with "FAN" button.
3
Set the temperature to 18°C with the temp. setup buttons.
4
After confirming a signal receiving sound "beep"
immediately set the temperature to 19°C with the temp.
setup buttons.
5
After confirming a signal receiving sound "beep"
immediately set the temperature to 18°C with the temp.
setup buttons.
Repeat procedures
6
wireless receiver section flash in approx. 10 seconds, and the air conditioner starts operation. If any of these
indicators does not flash, repeat procedures
7
Upon completion of the test run, push "ON/OFF" button to stop operation.
<Overview of test run operations using the wireless remote controller>
n Cooling test run:
ON/OFF → 18°C → 19°C → 18°C → 19°C → 18°C → 19°C → 18°C → (test run) → ON/OFF
n Heating test run:
ON/OFF → 30°C → 29°C → 30°C → 29°C → 30°C → 29°C → 30°C → (test run) → ON/OFF
Always select
[HIGH] air volume.
English-21
Cooling test run
Cooling test run
Cooling test run
→ → →
4 5 4 5
. Indicators "Operation" (green), "Timer" (green), and "Ready" (orange) in the
2
to
2
2
2, 7
Description
Set the temperature to 30°C with the temp. setup buttons.
After confirming a signal receiving sound "beep"
immediately set the temperature to 29°C with the temp.
setup buttons.
After confirming a signal receiving sound "beep"
immediately set the temperature to 30°C with the temp.
setup buttons.
5
.
3, 4, 5, 6
21
Hearting test run
Hearting test run
Hearting test run