NextBase NBDVR402G Bedienungsanleitung Seite 38

FEHLERBEHEBUNG
Video Image is blurred.
I can not insert the Micro SD card.
I can not remove the Micro SD
card.
Video files can not be played.
Video file playback is jumpy.
Playback upon the Driver
Recorder Player is jumpy.
The sound is not synchronised
with video during playback.
Video has no sound.
Photograph is blurred.
I can only record a few minutes
of video on my SD card.
Mass Storage or PC Camera
function does not work.
The sucker will not stay in place
upon my windscreen.
The AV Out from my iN-CAR CAM
just buzzes on my TV.
I get the message "Card Error"
on screen.
I get the message "Memory error"
on screen.
I get the message "Card Full"
on screen.
36
Remove the protective lens cover, clean the lens, clean the windscreen!
Micro SD card are very small and require delicate use. Align the card with
the diagram shown upon the device and insert the card until you feel a
slight spring resistance. You now need to push the card, using your finger
nail, until you hear and feel a small latch. Release pressure and the card
will stay retained within the device.
With the card previously installed, you now need to push the card further
inwards slightly, using your finger nail, until you hear and feel a small latch.
Release pressure and the card will spring out sufficiently for you to take
hold of it.
The video files from the iN CAR CAM are in MOV format and may not be
compatible with your PC if suitable playback software is not installed.
Install the supplied Driver Recorder Player software and the additional
Codecs if necessary.
Remove the SD card and reformat to remove non-contiguous files.
For best recording use a branded class 10 type (30MB/s) SD card of
8 to 32GB recommended size. Recommended video playback software
Is the supplied Driver Recorder Player Playback.
PC may not be sufficient for the playback task, try an alternative PC.
The Codecs upon your PC may not be compatible or the latest standard.
Download the latest Codecs from
InCarCam/downloads and install them accordingly.
The Codecs upon your PC may not be compatible or the latest standard.
Download the latest Codecs from
InCarCam/downloads and install them accordingly.
Ensure that "Record Audio" setting is turned ON within the Video Menu.
Hold the camera still whilst taking the photo. Please be aware the photo
is taken around 1 second after the shutter noise is heard.
Change the recording size (Loop recording function) to a smaller size.
Increase the size of the SD card. Max 32GB.
The Mass storage function will work on both Windows and Mac, however
the PC camera is only Windows compatible. . Restart the PC, as this may
be required for the necessary driver to be loaded correctly. Disconnect
and reconnect the In-CAR CAM. Contact NEXTBASE for the required driver.
Moisten the sucker slightly before affixing upon the windscreen. Ensure that
the lever is fully pushed towards the windscreen. Make sure that the glass is
smooth and clean. Do not stick to glass that has any non-smooth effect or
paint whatsoever. Affix to the glass firmly and then push the lever to the full
extent.
Ensure that the AV cable is correct. Use a stereo 3.5mm jack plug where
the tip is the video and the ring is the audio signal.
The SD card has become unuseable by the iN-CAR CAM. Remove useful
files using your PC and then perform a "FORMAT" upon the SD card from
within the SETUP menu.
The SD card has become unuseable by the iN-CAR CAM. Remove useful
files using your PC and then perform a "FORMAT" upon the SD card from
within the SETUP menu.
The SD card has become full as the Loop recording function is set to
OFF. Set the "Loop Recording" function to 3 mins (default) to enable the
cycle recording function and automatic deletion of older files.
http://www.nextbase.co.uk/categories/
http://www.nextbase.co.uk/categories/