NextBase NBDVR402G Bedienungsanleitung Seite 20

TROUBLE SHOOTING (CONTD.)
My iN-CAR CAM shuts down by
itself after a while.
No power to my iN-CAR CAM,
but it works upon my PC.
The SD card in my iN-CAR CAM
can not be read.
I can't delete files on my SD card
within the iN-CAR CAM.
The screen blanks after a few
minutes upon my iN-CAR CAM.
I get the message "Cluster Wrong"
on screen.
The Driving Recorder Player will
not open.
The iN-CAR CAM can not lock
onto satellite
I have turned on 'motion detection'
and now can't stop the recording.
The battery will not charge.
The battery only last 30 seconds
The battery only lasts 6 minutes.
18
Either the battery has gone flat, or there is no power to the iN-CAR CAM
and the AutoPower Off period (which is in the SETUP menu) has been
triggered.
The cigarette power cable is not working. Inspect the fuse in the Car Power
plug. Replacement fuse = 2A 20mm type. If the fuse if found to be blown,
inspect the power cable for damage which may have caused the fuse blow.
Use a good quality branded SD card between 4GB and 32GB (suggested)
and format the card from with in the SETUP menu of the iN-CAR CAM.
Check to see if these files are 'protected', if so please follow instructions
to 'un-protect'
The screen saver is set to ON. Change settings to OFF if required.
Default setting is off.
The SD card has been formatted in another device and the Cluster Size is
not compatible. Simply use the MENU, SETUP option to re-format the SD
card from within the iN-CAR CAM.
For Windows operating systems the player requires an internet connection
to open, if this is not available please view files using alternative playback
software, i.e. QuickTime or VLC.
After power on and with the device mounted with clear view of the sky it can
take up to 10 minutes to find the three satellites required to achieve a stable
signal. Reception can also be affected by atmospheric conditions and the
proximity of buildings / trees obscuring the sky.
The iN-CAR CAM will start a recording whenever motion is detected, when
function is to be turned off firstly shutdown the iN-CAR CAM and remove the
SD card, this will avoid recording being activated accidentally. Switch back
on the and within the setting menu and turn off the 'Motion Detection'.
To protect from over-charging the battery will only charge when the
iN-CAR CAM is turned on.
The battery will only receive charge when the iN-CAR CAM is turned on,
please reconnect car adaptor and leave the iN-CAR CAM turned on.
Charging takes approximately 90 minutes and a full charge is indicated by
a red LED.
This is normal, the battery design allows the 'Auto Power Off' feature to
function in event of power loss within the vehicle. It is not intended as an
alternative power source to replace the supplied car adaptor.