Troubleshooting; Specifications; Conformity Information - Megasat Profi-Line-Serie Bedienungsanleitung

7. Troubleshooting

If you receive a bad or no signal, it may have the following reasons:
• Make sure all cable connections are intact and each connection is properly tigh-
tened.
• Check the inside of each F connector for dirt or a possible connector shell.
• Check again the setup of the antenna (horizontal and vertical angle). Possibly.
the antenna points you to another satellite.
• Make sure that there are no obstacles such as trees, buildings, windows, corn-
ers or overhangs of the roof that can affect the signal.
• An RG 6 cable with a solid copper core conductor is strongly recommended
because it has a much lower DC voltage drop compared to an RG 6 cable with
a copper-plated steel core conductor.
• Make sure the TV is set to the correct input (eg HDMI 1), depending on which
input the receiver is plugged in to.
• Make sure the receiver is turned on and a corresponding station list is loaded
for the selected satellite.
16

8. Specifications

FEATURES
• Input frequency: 10.7 – 12.75 GHz
• Polarization: Linear (vertical / horizontal)
• Antenna gain: 33 dBi @ 12.75 GHz
• LNB output: 1, 2 or 4
• LNB output frequency: 950 - 1.950 MHz / 1.100 – 2.150 MHz
• L.O. Frequency: 9.75 GHz / 10.6 GHz
• LNB gain: min. 55 dB / max. 66 dB
• Gain flatness: 5 dB
• Power supply: 12 – 14 V DC (V) / 16 – 19 V DC (H)
• Power consumption: max. 160 mA
• Operating temperature: -20° C to +60° C
• Storage temperature: -40° C to +80° C
OTHER
• Dimensions: 525 x 290 x 68 mm (without LNB)
• Dimensions: 525 x 290 x 145 mm (with LNB)
• Weight: 4.5 kg

Conformity information

Hereby, Megasat Werke GmbH declares that the following product is in compli-
ance with the essential requirements and other relevant provisions of directives
2014/30/EU (EMC), 2014/35/EU (LVD) and 2014/53/EU (RED):
Flat antenna D1 Profi-Line (Art-No. 200210)
Flat antenna D2 Profi-Line (Art-No. 200211)
Flat antenna D4 Profi-Line (Art-No. 200212)
The declaration of conformity for this product is located at the company:
Megasat Werke GmbH, Industriestraße 4a, D-97618 Niederlauer
The declaration of conformity can be downloaded from our homepage:
www.megasat.tv/support/downloads
17