3. Mounting options
3.4 Mounting on a window
1
2
3
12
Mount the window holder A to the
mounting arm. Use two screws
M6 x 10 for this purpose.
Mount the window holder B to the
mounting arm. Use two screws
M6 x 10 for this purpose.
Hang the antenna with the window
holder A in the fold of the window. The
window holder B serves as a support.
You can adjust the distance from the
window to the outside wall with the two
fixing screws M6 x 10 on the window
holder A. The mounting arm should
generally be mounted horizontally.
4. Prepare and lay coaxial cable
When installing the F-connectors, make sure that they are installed correctly. Fai-
lure to correctly install the F connectors may result in signal loss or short circuit.
The weather protection is only necessary for the exterior of the antenna.
Route the coaxial cable from the antenna to the satellite receiver. Make sure that
you do not damage the cable during installation or that there are no kinks. Do not
exceed the length of 30 meters, otherwise there may be signal loss. If you would
like to lay the cable through a window, please use a suitable window feedthrough.
Connection
at the LNB
15 mm
weather proof
8 mm
F-connector
3 mm
Connection to the
receiver (LNB In)
13