Check The Lock; Profiles With Thermal Separation; Finishing Profile Webs - Assa Abloy MSL sFlipLock Serie Montage- Und Bedienungsanleitung

Check for full
functionality
Fig. 8 :
Bolt is free of transverse
loads (F )
Q
1 Strike plate
2 Bolt
3 Faceplate
X minimum 2 mm
A
EN
58

Check the lock

1 Check all lock functions.
2 Check whether the latch and trip latch of the lock are pushed back from the same impact edge when
closing the door ("Profiles with thermal separation", page 58).
3 Check whether all bolts can move in and out freely without any transverse load after assembly (Fig. 8).
 The lock is now completely assembled and checked for correct operation.
X

Profiles with thermal separation

At tention!
Lack of finishing can lead to product malfunction: When using profiles with thermal separation, the
components listed below must be finished with additional work.
Aluminium stop edges can lead to destruction: Aluminium abrasion can destroy the lock or strike plate.

Finishing profile webs

When closing the door, the latch and trip latch must slide over a flat surface ("Self-locking function",
page 49). Some door frames, such as those with thermal separation, may feature a profile web that
interferes with the sliding surface. This profile web must be removed in the area of the latch and trip latch.
ASSA ABLOY (Schweiz) AG recommends using a strike plate with a tab aperture to create a flat sliding
surface
1 Cover existing profile grooves or other uneven areas.
2 Remove the webs. The profile web in the latch area must be removed down to the mounting level.
3 When closing the door, check whether the latch and trip latch can slide unhindered over a flat surface
into the closing position.
 The profile webs are smooth and the locking function is guaranteed.
F
= 0
Q
N
F
= 0
Q
N
1
2
3
Assembly