Assembly; Preparing For Assembly; Electrical Connection - Assa Abloy MSL sFlipLock Serie Montage- Und Bedienungsanleitung

!
!
!
Prepare and
clean the
lock recess
Connect the cable
EN
56

Assembly

Warning!
Risk of death due to electric shock: Incorrect wiring is life-threatening.
· Only allow a qualified, skilled electrician to connect the electricity supply.
Caution!
Risk of injury caused by sharp edges and metal filings: Drilling and other machining operations can cre-
ate sharp edges and metal filings which may cause injury.
· Always particularly protect your eyes with suitable protective goggles.

Preparing for assembly

Caution!
Unsuitable doors impair personal protection and burglary protection: Only approved and technically
flawless doors are suitable for installing the lock.
· Before installing the lock, check that the door is properly fitted and is not warped.
· Check that the door is approved for use with the lock.
1 Create the lock recess at a suitable vertical installation position in the door leaf. Allow for an extra
30-mm depth for the cable loop.
2 Create the drill holes for the fixing screws as in line with Fig. 14 and Fig. 15.
3 Drill the holes for the lock fittings (only with the lock removed).
4 Clean the lock recess and all drill holes by blowing out or vacuuming.

Electrical connection

1 Prepare the wiring for the lock
("Electrical connection", page 60).
2 Connect the power supply and control cables
("Flexible cable transition", page 70).
Assembly