DeWalt D26411 Bedienungsanleitung Seite 24

EngLIsH
Air temperature adjustment knob (D26411)
4
LCD air temperature indicator and adjuster (D26414)
Nozzle
5
Tool hanging ring
6
Heat barrel cover
7
Intended Use
Your heat gun has been designed for stripping paint, soldering
pipes, shrinking PVC, welding and bending plastics as well as
general drying and thawing purposes.
DO nOt use under wet conditions or in the presence of
flammable liquids or gases.
The heat gun is a professional power tool. DO nOt let children
come into contact with the tool. Supervision is required when
inexperienced operators use this tool.
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
without supervision.
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with this product.
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.
Air Temperature (Fig. A)
D26411
The air temperature can be adjusted to suit a wide range of
applications. Turn the air temperature adjustment knob
clockwise or counterclockwise for higher or lower heat.
D26414
• Press and release the LCD air temperature indicator
and adjuster to set the desired temperature in
4
10 °C increments.
• To continously increase or decrease the temperature press
and hold the LCD air temperature indicator and adjuster
• Release the indicator when desired temperature or
minimum/maximum temperature is reached.
• The display shows the actual rising/falling temperature until
the desired temperature is reached.
Set and Forget Temperature Control System
D26414
The desired temperature is stored in the memory of the tool.
Each time the heat gun is turned on, the heat gun heats to
the last temperature setting, with respect to air flow. If unsure
about the setting, always start with a low temperature setting
and gradually increase the temperature until the desired setting
is reached.
22
Applications
The table below suggests settings for different applications.
Setting Applications
Low • Drying paint and varnish
• Removing stickers
• Waxing and dewaxing
• Drying wet timber prior to filling
• Shrinking PVC wrapping and insulation tubes
• Thawing frozen pipes
Medium • Welding plastics
• Bending plastic pipes and sheets
• Loosening rusted or tightly fastened nuts and bolts
High • Removing paint and lacquer
• Soldering plumbing joints
• Removing linoleum or vinyl floor tiles
To Attach the Correct Accessory
This tool is supplied with a set of accessories for
different applications.
Icon
Cone nozzle
50 mm Fish tail
surface nozzle
1. Make sure the on/off switch
is disconnected from the power source. Ensure the nozzle
has cooled down.
2. Place the desired accessory onto the nozzle.
4
OPERATION
Instructions for Use

WARNING: Always observe the safety instructions and
applicable regulations.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
4 .
source before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.

WARNING: Make sure the nozzle always points away
from you and any bystanders.

WARNING: DO NOT drop anything into the nozzle.
Proper Hand Position (Fig. B, C)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
Description Purpose
Shrink sleeving (heat over
concentrated small area)
Drying, removing paint,
removing vinyl or linoleum,
thawing (heat spread over
wide area)
1 is in position O and the tool