Arming And Disarming The System; Arming The System; Arming In Away Mode - Bosch AMAX panel 4000 EN Bedienungsanleitung

AMAX panel 4000 / AMAX panel 4000
EN
2

Arming and Disarming the System

2.1

Arming the System

Notice!
When the number of incorrect code entries on the keypad reaches a specified number, the
keypad will automatically lock for 180 seconds and alarm is reported. If the keypad is idle for
1 minute, the system will automatically exit from any operational mode.
NOTICE!
2.1.1

Arming in AWAY Mode

Arming the system in AWAY Mode is normally performed when you leave the premises and
require that all zones are activated in a ready state to detect an intrusion.
Keypad Arming
There are two methods to arm your system in AWAY Mode.
Method 1:
To arm the System in AWAY mode enter your code and press [#].
It beeps twice, the AWAY indicator flashes slow, and exit time starts.
After exit time, the AWAY indicator turns is lit.
Method 2:
To arm the System in AWAY mode press and hold [#] until it beeps twice.
The AWAY indicator flashes slow, and exit time starts. After exit time, the AWAY indicator is lit.
Please contact your installer to enable/disable this function.
Telephone Remote Arming
The user dials the control panel number. The control panel answers the call and issues a long
beep. After the long beep, the user must press the [#] key. When the Panel receives the signal
it will confirm the arming of the control panel with a high tone.
Please contact your installer to enable/disable this function.
Notice!
Telephone arming is possible when the system has only 1 assigned area.
Key Switch Arming
Users can use a key switch to Arm and Disarm the system. When the Key switch is activated,
the AWAY indicator flashes slow and exit time starts. After exit time, the AWAY indicator is lit.
When the Key switch is deactivated, the system is disarmed and Away indicator is off.
Bosch Sicherheitssysteme GmbH User Guide
Arming and Disarming the System | en
2013.07 | 03 | F.01U.267.114
11