Modster COMPASS Betriebsanleitung Seite 27

Manual
After Driving
1. Turn off the controller.
2. Turn off the transmitter.
3. Remove the transmitter batteries from the transmitter.
4. Fully dry the boat on the inside and the outside. Remove the hatch and radio box cover before storing your boat.
5. Repair any damage or wear to the boat.
6. Make note of lessons learned from the trimming of your boat, including water and wind conditions.
Tip: The hook and look strips in the boat may retain water. To dry them press on them with a dry cloth.
NOTE: Always store the boat without its hull to prevent mold damages.
8. Maintainance and Care
Driving tipps:
Please do not drive in close areas to other boats, objects in the water, waves, swirls, animals or plants. Do not drive near swimming people, in
water parks or on fish ponds. Always ask those responsible for permission to use the boat at the appropriate location. The maximum speed
is achieved only with calm water surface and perfect wind conditions. If there is too much swell, wind or even violently controlled changes
of direction, the boat may capsize. Get used to the driving and steering behavior of the boat slowly.
Sail Checklist
NOTE: This checklist is NOT intended to replace the content included in this instruction manual. Although it can be used as a quick start
guide, we strongly suggest reading through this manual completely before proceeding.
1. Always turn the transmitter on first.
2. Check each sail, rigging rings and fitting is properly installed and adjusted.
3. Sail the boat in a appropriate water environment.
4. We suggest you to switch Dual Rate button to 100%.
5. After running, turn off receiver power.
6. Unplug receiver batteries.
7. Always turn off the transmitter last.
8. Drain water out of boat hull, then place the boat in a dry shade.
www.modster.at
MODSTER COMPASS
27