Modster COMPASS Betriebsanleitung Seite 22

Betriebsanleitung
Tie the other end of the cord to a clevis
through a bowsie, then hook the clevis
to the eyelet of jib boom as shown in
picture.
Unleash the Dyneema cord circled on jib boom, then lead it through three eyelets on deck as shown in picture, finally tie it on the pre-in-
stalled clevis at the end of port.
Unleash the Dyneema cord circled on main boom, then lead it through the cord holder and eyelet on deck, then finally tie on the pre-in-
stalled clevis at the end of port.
Move Silicone Rings("SR" for short) to appropriate position as shown in picture. If further rigging needed, adjust refering to below inst-
ruction:
(1) Move SR1 to adjust main sail until it is appropriately tight, but leaving little bending room so that it can sail. Normally if in strong wind
environment it needs more bending room, in gentle wind environment it needs less bending room.
(2) Move SR2 to adjust the Dyneema cord tied in step 13 if it is too tight(move to SR3 direction) or too loose(move to SR1 direction), in
order to keep the main boom in center position.
(3) Normally you don't need to move SR3, keep it in the position as shown in picture.
22
Hook the clevis to the forestay fitting part,
keep its eyelet pointing parallel with the
hull.
MODSTER COMPASS
Cut a length of Dyneema cord at about
200mm, tie one end on SR7, then lead
the cord through a bowsie and eyelets on
deck as shown in picture.
www.modster.at